Hookup for non Icom Amplifier

Check  on page 19 of the small manual you are going to use the AAC plug if you purchased the radio new you have the 13 pin plug all ready wired up for you. You will need to extend the wires from the plug and shrink tube the wire
pin 3  orange wire this is for amp on HF
pin 7 purple for 2 meter and 440 amp
pin 8 gray this  the 12 volt for the relay .
I used a small relay solder the wire shrink tube them and install the relay in a small plastic pill bottle on the  two for HF go to the coils side of the relay  on the points side make up a cable and solder the relay other end solder on a RCA jack. If you don't want to solder the RCA jack buy a cable how ever long you need with RCA already made up the just cut one RCA jacks off and solder to relay . Here is picture from the manual page 19 I used a 1N4001 diode

 HERE IS A LINK FOR A KIT  THAT IS VERY POPULAR   

http://hamgadgets.com/n4tze.com/

back.gif - (25K)