JT65 and JT9 setup FLEX 1000,1500,3000,5000

The screen shots are from a Flex 5000,but setup is the same on all older Flex radio's

Here the com port are set

Cat set on com 10

Audio set com 30

set radio upper right corner to Kenwood TS-2000

Tick all box's like the screen

SET LIKE THIS

VAC SETTING

JT65 PROGRAM VIRTUAL SETTING AS PICTURED ABOVE

SETTING BELOW SET AS SHOWN IN THE SCREEN SHOT

BELOW THE FREQUENCY AND  A LITTLE TO THE LEFT ADJUST THE SLIDE TO ABOUT MID POINT, IF THIS ISN'T ADJUSTED YOU WILL NOT RECEIVE

ON FLEX SCREEN SET DIGU AND POWER TO 70 WATTS

KEPT YOU VAC TX GAIN TO A NEGATIVE NUMBER  CHECK YOU ALC KEPT IT BELOW "0"

IF YOU ARE HAVE DISTORTED AUDIO SEE SETTING BELOW

          

After the Virtual sound has been added Windows set the default to a lower setting .You need to go and edit Virtual sounds 1 and 2 to these screen shots or if your sound card supports 32x 48000 dual channel select that.

also kept ALC to 0 or a negative number and check ALC Comp also for a negative number.

***************************************************

 

Never let the ALC go above the Zero 0 zero or towards the min

And don't for get about the Audio bug on most older computer running Windows 7 & 8 & 10      

                     Bug fix 1

                 Bug fix 2

FLEX-3000 DIGI AUDIO SETUP  

back.gif - (25K)