Support Bracket also called Export Braces

When I upgraded to the 5.0 I had to remove fender braces. This is what I did to replace them. Remember I'm on a budget ,      ("5.0 on a shoe String web site") so I started looking at what was on line what I found wasn't to appealing for my budget. Here is what I found . Cost from $126.00 plus shipping  to $165.00 plus shipping. The picture below is well engineered well worth the money .

If you got the money go for it . You can make these out of pipe flatten out and drilled . Probably under twenty dollars.

What I used was clevis rods I found on internet USA made . Less than $8.00 apiece , and the clevis ends with bearing for $4.00 a piece. For a total of $32.00 plus shipping I got them. Size I used , was 13" long 7/8" ID. 7/16 x 24 thread left and right thread.

www.speedpartz.com is the web address

 Next problem clevis brackets  

 I had looked for several days found some at a speed shop cost $22.00 I need four of them, plus they need to be ordered and a another shipping cost. Ok tried hardware store no luck . Looked in parts store remember I work in one . Found the perfect thing a heavy duty universal tail pipe hanger PT. # 17175 . Less than $3.00 apiece. You have to knock out two rivets and open two holes up. These part looks just like the $22.00 part. I can't believe it. Don't worry about mounting the clevis bracket to the shock tower. You will need to make two brackets .  I use 1/4" aluminum 6061 plate to make my bracket.    The cost of the aluminum was total of $6.00 scrap aluminum place. You will also half to replace shock tower bolts they are called Carriage Bolts  , they are 3/4" long you will need 1 inch to 1 1/4" long. You will need to grind the heads down to clear the mounting area. (note use flat bladed screw driver and hammer to reinstall them) .

Here is the final piece .

Here is a couple pictures.

Falcon Home page

Back to Falcon-5.0 on a shoe String Swap Pages

Converted to 5.0.EFI Parts Needed

Disclaimer: This site is not intended to instruct or teach anyone in proper or safe methods of working on or maintaining a car and the author takes no responsibility for the use of the information contained herein. This site is not associated with Ford Motor Company. Falcon is a registered trademark of Ford Motor Company. Other product and company names mentioned herein maybe the trademarks of their respective owners. Any usage or adaptation of any or all of the information provided here or on any or all of my web pages is purely at your own risk. You must take into account your own circumstances and vehicle requirements when attempting to utilize any or all of the information provided on any or all of my web pages. I assume no liability or responsibility for any results, damage, or unforeseen circumstances related in any way to the usage or adaptation of any or all of the aforementioned information. Enjoy

Contents of this page belongs to Jim Keller 2005. Please link b